The operation of high-frequency induction heating equipment is divided into these simple parts

What is the working principle of high-frequency induction heating equipment? It uses its high-frequency large current to flow to the heating induction coil that is wound into a ring state or the required shape. High-frequency induction is usually made of copper hollow tubes.

What are the main uses of high frequency induction heating equipment? Metal heat treatment, metal quenching, metal annealing, metal tempering, metal heat penetration, metal brazing, silver welding, brazing, metal thermal type, metal smelting, metal embedded plastic etc. will use high frequency induction heating equipment

Operation steps of the device:

1) Water: Start the water pump and observe whether the water flow at the water outlet is normal.

2) Power on: first close the knife, then turn on the air switch at the back of the machine, and then turn on the power switch on the control board.

3) Setting: Select the operation mode (full automatic, semi-automatic, manual and foot control) according to your needs. When automatic and semi-automatic control, you need to set the heating time, holding time and cooling time (each time cannot be set to 0, otherwise it will not work properly). automatic cycle). Before using it for the first time and before you are proficient, you should use manual or foot control.

4) Start: Before each start, the heating power potentiometer should be adjusted to the minimum as much as possible, and then slowly adjust the temperature to the required power after starting. Press the start button to start the machine, at this time the heating indicator on the panel is on, and there will be a sound of normal work and the simultaneous flashing of the work light.

5) Observation and temperature measurement: During the heating process, visual inspection is mainly used to determine when to stop heating based on experience. Inexperienced operators can use a thermostat to detect the temperature of the workpiece.

6) Stop: When the temperature reaches the requirement, press the stop button to stop heating. You can start it again after replacing the workpiece.

7) Shutdown: The machine can work continuously for 24 hours. The power switch should be turned off when not in use, and the knife or the air switch at the rear of the machine should be turned off when not in use for a long time. When shutting down, the power should be cut off first and then the water should be cut off, so as to facilitate the heat dissipation inside the machine and the heat of the induction coil.

Where are high-frequency induction heating equipment used in life? High-frequency induction heating equipment is mainly suitable for industries such as high-frequency induction welding, high-frequency induction heat treatment, and high-frequency induction metal melting. Such as: welding of carbide saw blades, diamond tools, drilling tools, turning tools, planers, milling cutters, reamers and other cutting tools; heat treatment of standard parts, bolts, power tools, hardware tools, hand tools; pliers, wrenches, rotary Tools, hammers, axes, auto parts, crankshafts, connecting rods, piston pins, crank pins, sprockets, camshafts, valves, various rocker arms, rocker shafts; various gears, spline shafts, transmission branches in the gearbox High-frequency quenching treatment of half shafts, various small shafts, various forks, etc.

The service life of the machine is limited. To prolong the service life of the machine, it is necessary to pay attention to the maintenance work, and the high-frequency induction heating machine is also required. When the high-frequency induction heating machine is used in a place with poor air environment, dust should be prevented from entering the inside of the machine, and water must not be splashed into the machine. To keep the cooling water clean, change it regularly. High temperature environment should maintain air circulation.